Fine-tune your sound the way it's meant to be heard

The IsoAcoustics ISO-L8R200 Speaker Stand Line-Up

IsoAcoustics offers two sizes of audio stand to fit your speakers. Each size is optimized to get the most from your particular speaker system.

Stands can be configured to 3" or 8" in height, with inserts that provide a variety of tilt-up and tilt-down adjustments. In the lowest configuration, the monitor can be tilted down to focus the tweeter to a height below the original supporting surface - providing superior isolation and sound improvement.

Choose your set-up:

ISO-L8R200 Short

In this case, the audio speaker stand is configured for 3" in height. Speaker can also be tilted for optimal listening angle. Usually speakers will be situated on a desktop or table.

ISO-L8R200 Long

Speaker stand is configured for 8" in height. Speaker can also be tilted up or down for exact listening angle. Can also be used for floor applications.

IsoAcoustic's unique patented design provides superior audio performance by supporting the PIF Principles in acoustic design.

Height Adjustment

An important aspect of the speaker stand design is the ability to adjust the height and tilt angle of the supported speaker enclosure to optimize its position relative to the listener. Two lengths of tubing along with 2 sets of end-plug pairs provide 14 steps of height adjustment as the combinations are used to tilt the speaker up and down. The stand can be assembled and reconfigured repeatedly to establish the ideal position off the supporting surface and focused towards the listener.

In a typical Desktop Audio Workstation (DAW) configuration, the listener is positioned 3 to 4 feet from the monitors with ear level approximately 20" above the work surface. An enclosure containing an 8" speaker may position the high frequency driver 12" from the bottom while an enclosure with a 6" speaker may position the high frequency driver only 8" from the bottom. Raising and tilting these examples to their optimum position can easily be achieved with this speaker stand design. This speaker stand configuration is also suited for applications over longer distances such as in large recording studios or with consumer products where home stereo speakers may ideally need to be raised 6" off the floor and tilted up 8 degrees.

Tilt Adjustment

The tube lengths and end-caps combinations provide a simple means to establish optimal adjustment of large and small monitors over the typical 36 to 48 inch listening distance for mixing and evaluation.

Isolators

ISO-L8R200 speaker stands prevent the transfer of speaker cabinet energy to surrounding surfaces, effectively isolating the speaker from the desktop, bookshelf or other surface. By allowing the speaker to perform in free space, it's able to sound the way it was intended. The end result is a more accurate, satisfying sound, which makes mixing and listening a better experience.